Diagnostic Fault Information
WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
- Always perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- An open fault in any engine control module (ECM) relay circuit will cause a no crank, no start condition and no communication with the scan tool.
DTC P2510
| ECM Circuits | Short to Ground | Open | Short to Voltage |
|---|---|---|---|
| IGN Relay Control | P25101 | 2 | 2 |
| IGN 1 Voltage | 2 | 2 | P25101 |
| Battery Voltage | P2510, P2610 | P2510, P2610 | - |
| 1
DTC will set only after the ECM powers down 2 These circuit faults will cause a loss of communication with the scan tool and a no crank, no start condition. |
|||