Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0101, P0102, P0103, P0106, P0107, P0108, P0112, P0113, P0116, P0117, P0118, P0120, P0128, P0131, P0132, P0134, P0135, P0151, P0152, P0154, P0155, P0200, P0220, P0300, P0442, P0446, P0452, P0453, P0455, P0496, P1125, P1258, P1516, P2101, P2108, P2135, U0107 are not set.
The ECT Sensor parameter is more than 60°C (140°F).
The EVAP Purge Solenoid Command parameter is more than 1 percent.
The MAF Sensor parameter is between 29-55 g/s.
The Engine Speed parameter is between 1,000-3,000 RPM.
The TP Indicated Angle parameter is 5 percent more than the value observed at idle.
The Loop Status parameter is closed.
The Ignition 1 Signal parameter is between 10-18 volts.
The Fuel Tank Level Remaining parameter is more than 10 percent.
The Engine Run Time parameter is more than 160 seconds.
The above conditions are met for 1 second.
This diagnostic runs continuously when the above conditions are met.