LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2)) >> Repair Instructions >> Flexplate Replacement (5.3L Engine w/RPO HP2) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission. Refer to Transmission Replacement (5.3L Engine w/RPO HP2) .
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the J 46093  (1) and bolts.
    Fig 1: View Of J 46093 & Bolt
    GM1277133Courtesy of GENERAL MOTORS CORP.

    The flange of the J 46093  should locate into the hole in the flexplate. Use two M10 1.5 x 40 mm bolts for proper tool operation.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  3. Remove the flexplate bolts.
    Fig 2: View Of Flexplate & Bolts
    GM1281915Courtesy of GENERAL MOTORS CORP.
  4. Remove the flexplate.
scientia non olet · About LEMON Manuals