Automatic Transmission Oil Cooler Flushing and Flow Test (J 45096): Clean-Up

WARNING: This page is about a different variant/trim than selected.

Turn the main function switch to the IDLE position and allow the supply vessel pressure to dissipate.

Fig 1: View Of Main Power Switch & Main Function Switch
Courtesy of GENERAL MOTORS CORP.
Turn the main power switch to the OFF position.

IMPORTANT: A small amount of water may drain from the bottom of the unit when the air supply is disconnected. This is a normal operation of the built-in water separator.

Disconnect the supply and waste hoses and the 12-volt power source from the vehicle.
Disconnect the air supply hose from J 45096 . See Special Tools .

Fig 2: Applying Shop Air Supply Hose To Quick-Disconnect
Courtesy of GENERAL MOTORS CORP.
Dispose of the waste oil in accordance with all applicable federal, state, and local requirements.