LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission System Hoses/Pipes Replacement (35 Reg/Ext/Crew Cab w/35 gal Tank) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank Clips
    GM1854930Courtesy of GENERAL MOTORS CORP.
  1. Position and connect the EVAP pipe quick connect fittings to the rollover valve and the fuel tank module. Refer to Plastic Collar Quick Connect Fitting Service .
  2. Install the EVAP pipe to the fuel tank clips (1).
    3. Fig 2: EVAP Pipe & Fuel Tank Clips
    GM1854928Courtesy of GENERAL MOTORS CORP.
  3. Install the EVAP pipe to the fuel tank clips (1).
  4. Install the fuel tank. Refer to Fuel Tank Replacement (15 Reg Cab w/26 Gal Tank)  or Fuel Tank Replacement (25 Ext/Crew Cab w/26 gal Tank)  or Fuel Tank Replacement (15 Ext/Crew Cab w/26 gal Tank)  or Fuel Tank Replacement (15/25 Reg/Ext/Crew Cab w/34 gal Tank)  or Fuel Tank Replacement (35 Reg/Ext/Crew Cab w/34 gal Tank) .
scientia non olet · About LEMON Manuals