LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 996 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement (LY2/LY5/LH6/LMG) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Cover, Oil Seal, Camshaft Position Sensor, Bracket & O Ring
    GM1704625Courtesy of GENERAL MOTORS CORP.
  1. Inspect the CMP sensor O-ring seal for cuts or damage. If the seal is not cut or damaged, it may be used again.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal (3) onto the sensor.
  4. Instal the CMP sensor (2) to the front cover.
  5. Install the CMP sensor wire harness (5).
    6. NOTE: Refer to Fastener Notice .
  6. Install the CMP sensor wire harness bolts (1, and 6).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    7. Fig 2: View Of Electrical Connector, Cable Channel Bolt & Pin
    GM1697734Courtesy of GENERAL MOTORS CORP.
  7. Connect the engine wiring harness electrical connector (1) to the CMP sensor wire harness.
  8. Lower the vehicle.
scientia non olet · About LEMON Manuals