LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 989 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Bracket Replacement (4.8L, 5.3L, 6.0L, and 6.2L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Generator Bracket & Bolts (4.8L, 5.3L & 6.0L)
    GM847280Courtesy of GENERAL MOTORS CORP.
  1. Position the generator bracket to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the generator bracket bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    3. Fig 2: View Of Engine Wiring Harness, Clip, Bolt & Connector
    GM1696914Courtesy of GENERAL MOTORS CORP.
  3. Position the engine wiring harness clip (1) to the generator bracket and install the engine harness clip bolt (3).

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

  4. Install the power steering pump. Refer to Power Steering Pump Replacement (4.3L) or Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) or Power Steering Pump Replacement (6.6L) .
  5. Install the generator. Refer to Generator Replacement (4.3L)  or Generator Replacement (4.8L, 5.3L, 6.0L, and 6.2L)  or Generator Replacement (6.6L) .
scientia non olet · About LEMON Manuals