Circuit/System Verification
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, perform the speedometer gage sweep test with the scan tool. Verify that the speedometer gage sweeps from its low to high position.
- If the speedometer gage does not sweep from its low to high position, replace the IPC.
- Ignition OFF, raise the vehicles drive wheels.
- Engine ON, transmission in drive, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
- If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC.