LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 981 (Lighting Systems) >> Diagnostic Information and Procedures >> Interior Backlighting Malfunction (w/AN3) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the driver door switch while commanding the Driver Door Switch Integrated Sw. Backlighting Test ON and OFF with a scan tool. The switch backlighting should turn ON and OFF between commanded states.
    • If the backlighting does not turn On and OFF or remains always ON, replace the driver door lock and side window switch.
  2. Ignition ON, observe the driver memory/heated seat switch while commanding the Driver Door Switch Non-Integrated Sw. Backlighting Test ON and OFF with a scan tool. The switch backlighting should turn ON and OFF between commanded states.
    • If the backlighting does not turn On and OFF or remains always ON, refer to Front Door Switch Backlighting Circuit Test below.
  3. Ignition ON, observe the passenger door switch while commanding the Passenger Door Switch Integrated Sw. Backlighting Test ON and OFF with a scan tool. The switch backlighting should turn ON and OFF between commanded states.
    • If the backlighting does not turn On and OFF or always remains ON, replace the passenger door lock and side window switch.
  4. Ignition ON, observe the passenger heated seat switch while commanding the Passenger Door Switch Non-Integrated Sw. Backlighting Test ON and OFF with a scan tool. The switch backlighting should turn ON and OFF between commanded states.
    • If the backlighting does not turn On and OFF or remains always ON, refer to Front Door Switch Backlighting Circuit Test below.
  5. Ignition ON, observe the scan tool BCM Dimming Control Signal parameter while operating the dimmer switch from high to low. The reading should change from a high percent to a low percent as the switch is rotated.
    • If the reading does not change, refer to Dimmer Switch Circuit Test below.
scientia non olet · About LEMON Manuals