Front Side Door Trim Panel Replacement (SLT)
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedure
- Remove the door upper trim panel. Refer to Upper Extension Trim Panel Replacement .
- Remove the door window control switch. Refer to Door Lock and Side Window Switch Replacement - Driver Side
and Door Lock and Side Window Switch Replacement - Passenger Side
.
|
| 1 |
Front Side Door Locking Rod Knob Assembly
Tip:
- Lower the window.
- Ensure the locking rod is in the unlocked position.
- Use a flat-bladed tool to disengage the detent tab and then remove the knob by pulling upward.
- When re-installing, push the knob down until the detent tab touches the locking rod opening cover.
- Push the detent tab in to lock the knob to the locking rod.
|
| 2 |
Front Side Door Trim Panel Cover |
| 3 |
Front Side Door Trim Panel Cover Retainer (Qty: 3) |
| 4 |
Front Side Door Inside Handle Bezel Cover |
| 5 |
Front Side Door Trim Panel Bolt (Qty: 3)
Tighten:
2 N.m (18 lb in)
|
| 6 |
Front Side Door Trim Panel Assembly
Tip:
- Disconnect the electrical connectors.
- There are 2 hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY.
- If these hooks are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.
- When installing the trim panel start at the lock knob, pushing down and outward moving toward the upper front.
|
| 7 |
Front Side Door Cable Retainer
Tip:
Pull upward to disengage. |
| 8 |
Front Side Door Trim Panel Retainer (Qty: 12) |