Instrument Panel Carrier Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Instrument Panel Carrier

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Remove the instrument Panel Compartment Assembly. Refer to Instrument Panel Compartment Door Assembly Replacement (with RPO SLT) .
1	Instrument Panel Carrier to HVAC Screw (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Instrument Panel Carrier to Body Nut (Qty: 4) Tighten: 9 N.m (80 lb in)
3	Instrument Panel Carrier Bolt (Qty: 7) Tighten: 2.5 N.m (22 lb in)
4	Instrument Panel Carrier Assembly Procedure Note location and routing of the instrument panel wiring harness prior to removal of the instrument panel carrier assembly to ensure proper reinstallation. Disconnect the wiring harness from the instrument panel carrier assembly. With the aid of an assistant, remove the instrument panel carrier assembly from the vehicle. If replacing the instrument panel carrier assembly, transfer all necessary components.