Crankshaft Balancer Removal

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 41816-A Crankshaft Balancer Remover. See Special Tools .
J 41816-2 Crankshaft End Protector. See Special Tools .
J 42386-A Flywheel Holding Tool. See Special Tools .

Fig 1: View Of Special Tool & Bolts

GM1658136

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

IMPORTANT: Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.

Install the J 42386-A (1) and bolts. See Special Tools .
Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.

Tighten: Tighten the J 42386-A bolts to 50 N. See Special Tools .m (37 lb ft).

Fig 2: View Of Used Crankshaft Balancer Bolt

GM1658287

Courtesy of GENERAL MOTORS CORP.

Remove the crankshaft balancer bolt (139).
Do not discard the crankshaft balancer bolt. The balancer bolt is used during the balancer installation procedure.

Fig 3: View Of Crankshaft Balancer With J 41816 & J 41816-2 Removal Tools

GM1402060

Courtesy of GENERAL MOTORS CORP.

Use the J 41816-A (1) and the J 41816-2 (2) in order to remove the crankshaft balancer. See Special Tools .

Fig 4: View Of Crankshaft Balancer

GM1658138

Courtesy of GENERAL MOTORS CORP.

Remove the balancer (138).

Fig 5: View Of Special Tool & Bolts

GM1658136

Courtesy of GENERAL MOTORS CORP.

Remove the J 42386-A (1) and bolts. See Special Tools .