Leak Test Passes
WARNING: This page is about a different car, the 2007 GMC Sierra, 2007 GMC Cab & Chassis Sierra, 2007 Chevrolet Silverado, and 2007 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
If the pressure drop is less than 34 kPa (5 psi) in 15 seconds, the leak test passes. Remove the tester by performing the following procedure:
- Slowly bleed the air from the cooler by depressing the relief valve on the adapter plate.
- Remove the air hose, gage/regulator assembly, and both adapters.
- Connect the charge air hose to the turbocharger.
Tighten: Tighten the clamp to 8 N.m (70 lb in).
- Remove the adapter plate and install the intake air heater. Refer to Intake Air Heater Replacement .
NOTE:
Refer to Fastener Notice
.