Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Left Exhaust Pipe

Courtesy of GENERAL MOTORS CORP.

Position the exhaust pipe with a NEW gasket to the turbocharger.
Loosely install the exhaust pipe to turbocharger bolts.
Position the exhaust pipe with a NEW gasket to the exhaust manifold. Align the tabs on the gasket to face downward.
Loosely install the exhaust pipe to exhaust manifold bolts.

Fig 2: Exhaust Pipe To Exhaust Manifold Bolt Tightening Sequence -- Left Side

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Tighten the exhaust pipe bolts in the sequence shown.
Tighten: Tighten the bolts to 53 N.m (39 lb ft).

Fig 3: View Of Exhaust Outlet

Courtesy of GENERAL MOTORS CORP.

Install the exhaust pipe heat shield bolts.
Tighten: Tighten the bolts to 10 N.m (89 lb in).

Fig 4: View Of Left Exhaust Heat Shield & Nuts

Courtesy of GENERAL MOTORS CORP.

Install the left side exhaust heat shield (3) at the dash panel.
Install the heat shield nuts (2).
Tighten: Tighten the nuts to 9 N.m (80 lb in).
Install the transmission. Refer to Transmission Replacement .