Front Output Shaft Drive Sprocket Bearing Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP. Front Output Shaft Drive Sprocket Bearing Replacement
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 35512
and an arbor press, remove the bearing assemblies from the drive sprocket.
- Ensure the bearings are installed squarely into the drive sprocket bore.
|
| 1 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front
Tip:
- Install the bearing using the long side of the DT-48211
.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Driver Handle
- J 35512
Inner Pinion Bearing Installer
|
| 2 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear
Tip:
- Install the bearing using the short side of the DT-48211
.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Driver Handle
- J 35512
Inner Pinion Bearing Installer
|