Removal Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the auxiliary battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
- Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
- Remove the mega fuse cover (3).
- Open the starter solenoid cable cover at the positive battery terminal.
- Loosen the starter solenoid cable nut (5).
- Remove the starter solenoid cable from the positive battery terminal.
- Remove the starter solenoid cable clip (4) from the air conditioning (A/C) evaporator tube.
- Remove the starter solenoid cable nut (1) from the mega fuse stud.
- Remove the starter solenoid cable terminal (2) from the mega fuse stud.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the front 2 oil pan skid plate bolts, loosen the rear 2 bolts and remove the skid plate.
- Remove the starter solenoid cable clip (1) from the wheelhouse panel.
- Remove the starter solenoid cable clip bolt (2) from the frame.
- Remove the starter solenoid cable nut (1) from the starter.
- Remove the starter solenoid cable (2) from the starter.
- Lower the vehicle.
- Remove the starter solenoid cable from the vehicle.