Front Side Door Window Rear Channel Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Side Door Window Channels & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Position the door window as needed for service. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (YE9) or Front Side Door Trim Panel Replacement (SLT) . Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .
1	Front Door Window Run Channel Rear Bolt NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Front Door Window Rear Run Channel Tip: Raise the door window to the fully close position to gain access the run channel.

Callout

Component Name

Preliminary Procedures

Position the door window as needed for service.
Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement (YE9) or Front Side Door Trim Panel Replacement (SLT) .
Remove the water deflector. Refer to Front Side Door Water Deflector Replacement .

Front Door Window Run Channel Rear Bolt

NOTE: Refer to Fastener Notice .

Tighten: 10 N.m (89 lb in)

Front Door Window Rear Run Channel
Tip: Raise the door window to the fully close position to gain access the run channel.