Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: If replacing the condenser, add the refrigerant oil to the condenser. Refer to Refrigerant System Capacities for system capacity information.

Install the condenser to the vehicle.

NOTE: Refer to Fastener Notice .

Install the upper insulator retainers and the insulator retainer bolts.
Tighten: Tighten the bolts to 2.4 N.m (21 lb in).

Fig 1: Evaporator Tube To Condenser

Courtesy of GENERAL MOTORS CORP.

Connect the evaporator tube to the condenser using new sealing washers. Refer to Sealing Washer Replacement .
Install the evaporator tube nut to the condenser.
Tighten: Tighten the nut to 16 N.m (12 lb ft).

Fig 2: View Of Discharge Hose At Condenser

Courtesy of GENERAL MOTORS CORP.

Connect the compressor discharge hose to the condenser using new sealing washers. Refer to Sealing Washer Replacement .
Install the compressor discharge hose nut to the condenser.
Tighten: Tighten the nut to 16 N.m (12 lb ft).

Fig 3: Tie Bar & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the lower bolts to the hood latch support bracket.
Tighten: Tighten the bolts to 9 N.m (80 lb in).

Fig 4: Tie Bar To Radiator Brace & Bolts

Courtesy of GENERAL MOTORS CORP.

Install the radiator support. Access the bolts (1) from the rear of the upper radiator support. Refer to Radiator Support Replacement .
Tighten: Tighten the nut to 16 N.m (12 lb ft).
Evacuate and recharge the system. Refer to Refrigerant Recovery and Recharging .
Leak test the fittings of the component using the J 39400-A . See Special Tools .