LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 259 (Bumper System) >> Repair Instructions >> Bumper Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the rear bumper step pad to the bumper. Refer to Step Pad Replacement - Rear Bumper .
  2. Install the rear bumper step pad extensions to the bumper. Refer to Step Pad Extension Replacement - Rear Bumper .
  3. Install the rear bumper braces to the bumper. Refer to Bracket Replacement - Rear Bumper .
  4. Install the bumper (3) to the vehicle.
    CAUTION: Refer to FASTENER NOTICE .
  5. Install the inner and outer bumper impact bar brace retaining nuts (1) to the frame.

    Tighten 

    Tighten the inner and outer bumper impact bar brace retaining nuts to 50 N.m (37 lb ft).

    Fig 1: Installing Rear Bumper
    G02422918Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals