LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 256 (Interior Trim) >> Repair Instructions >> Garnish Molding Replacement - Lower Pillar >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door upper pillar garnish molding. Refer to Garnish Molding Replacement - Upper Pillar .
  2. Remove the seat belt through the slot in the front lower pillar garnish molding.
  3. Remove the 2 screws from the garnish molding.
  4. Grasp and gently pull the front door lower pillar garnish molding in order to release the retaining clips.
  5. Remove the front door lower pillar garnish molding from the vehicle.
  6. Inspect the front door lower pillar garnish molding for broken or missing retaining clips. Replace the retaining clips as needed.
    Fig 1: Removing Lower Pillar Garnish Molding
    G02423363Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals