Seat Belt Service Precautions
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Important: If the vehicle has been in a collision, refer to Repairs and Inspections Required After a Collision for additional information.
- Do not bleach or dye the seat belt webbing. Clean the seat belt webbing only with a mild soap and water solution and a soft brush or cloth.
- Keep sharp edges and damaging objects away from the seat belts. Avoid bending or damaging any part of the seat belt buckle or latch plate.
- Replace any seat belts which are cut or damaged in any way.
- Use only correct seat belt anchor bolts and screws.
- Tighten the bolts and the screws to the correct torque value. Refer to Fastener Tightening Specifications .
- When installing the seat belt anchor bolts, start the bolt by hand in order to ensure that the bolt is threaded straight.
- Some seat belts and retractors must be serviced as a set with service replacement parts only. Do not attempt to make repairs to the individual components which are only serviced as a set.
- Verify that the replacement part number is correct for the vehicle at that seating position. Do not substitute a seat belt from a different seating position.