LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 245 (Instrument Panel, Gages, And Console) >> Repair Instructions >> Knee Bolster Replacement - Left >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR. Refer to ZONE 3 .
  2. Remove the bolts (2) from the lower edge of the instrument panel (I/P) driver knee bolster panel (1).
  3. Pull the I/P driver knee bolster panel (1) towards the rear of the vehicle in order to disengage the retainers.
  4. Remove the I/P driver knee bolster panel (1) from the vehicle.
  5. Inspect the I/P driver knee bolster panel (1) for broken or missing retainers.

    Replace the retainers as needed.

    Fig 1: Removing I/P Driver Knee Bolster Panel
    G02422647Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals