LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Seat System) >> Repair Instructions >> Seat Replacement - Rear Bench >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat into the vehicle.
    Fig 1: Installing Rear Bench Seat
    G02423304Courtesy of GENERAL MOTORS CORP.
  2. Align the seat attaching points with the slots in the floor rail.
  3. Push the seat forward in the rail to lock the front of the seat risers onto the slots on the inside of the floor rail.
    Fig 2: Aligning Seat Attaching Points With Floor Rail Slots
    G02423305Courtesy of GENERAL MOTORS CORP.
  4. Remove the locking pin (3) from the stored position at the rear of the seat riser (2).
    Fig 3: Removing Locking Pin From Stored Position
    G02423306Courtesy of GENERAL MOTORS CORP.
  5. Locate the hole in the floor rail at the rear of the seat riser (2) and insert the locking pin.
  6. Rotate the locking pin (3) forward into the retaining clip.
    Fig 4: Inserting & Rotating Locking Pin Into Retaining Clip
    G02423307Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals