LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Push to Seat Connectors >> Terminal Repair

Terminal Repair

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Slip the cable seal away from the terminal.
  2. Cut the wire as close to the terminal as possible.
  3. Slip a new cable seal onto the wire.
  4. Strip 5 mm (3/16 in) of insulation from the wire.
  5. Crimp a new terminal to the wire.
  6. Solder the crimp with rosin core solder.
  7. Slide the cable seal toward the terminal.
  8. Crimp the cable seal and the insulation.
  9. If the connector is outside of the passenger compartment, apply grease to the connector.
scientia non olet · About LEMON Manuals