Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Important : If you reinstall an existing control switch in the compressor, use a new O-ring and a new retainer ring. An O-ring and a retainer ring is included in a new switch kit.
- Lubricate the new O-ring using new 525 viscosity refrigerant oil.
- Install the new O-ring into the groove in the switch cavity.
- Lubricate the control switch housing using new 525 viscosity refrigerant oil.
- Install the switch (2) into the switch cavity until the switch bottoms in the cavity.
- Install the A/C high pressure switch snap ring using the J-5403 . Ensure that the high point of the curved sides is adjacent to the switch housing. Ensure that the snap ring is properly seated in the switch cavity retaining groove.
- Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
- Leak test the fittings of the components using the J-39400-A .