LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Tilt Head Housing Replacement (Tilt) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to ZONE 3 .
  2. Remove the turn signal cancel cam assembly. Refer to Turn Signal Cancel Cam and Upper Bearing Thrust Washer .
  3. Remove the turn signal and multifunction switch assembly only. Refer to Multifunction, Turn Signal Switch Replacement .
  4. Slide the turn signal switch housing off to the steering column shaft assembly.
  5. Remove the tilt head housing and steering shaft as an assembly. Refer to Lower Bearing and Steering Column Jacket Replacement (Column Shift Tilt)  or Lower Bearing and Steering Column Jacket Replacement (Column Shift Standard)  .
  6. Remove the tilt head from the steering shaft.
    Fig 1: Removing Tilt Head From Steering Shaft
    G01217393Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals