LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Shift Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to ZONE 3 .
  2. Slide the shift lever seal (2) up the shift lever (4).
  3. If necessary, remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Disconnect the shift lever connector at the base of the column.
  5. Remove the shift lever screw (3) from the shift lever assembly (4).
  6. Remove the shift lever and seal from the column.

    Important:  The shift lever seal must be removed by sliding the shift lever seal towards the narrow section of the shift lever.

  7. Remove the shift lever seal (2) from the shift lever (4).
    Fig 1: Removing Shift Lever Assembly & Components
    G01217366Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals