LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Seal Replacement - Intermediate Steering Shaft >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the intermediate shaft seal (1) to the intermediate shaft bearing (2).
    Fig 1: Installing Intermediate Shaft Seal To Intermediate Shaft Bearing
    G01217310Courtesy of GENERAL MOTORS CORP.
  2. Install the intermediate shaft bearing. Refer to Intermediate Steering Shaft Bearing Replacement .
  3. Remove the J-42640 from the steering column lower access hole.
    Fig 2: Removing J-42640 From Steering Column Lower Access Hole
    G01217311Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals