LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement - Upper >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J-42640 in the steering column lower access hole.
  2. Remove the intermediate shaft bearing. Refer to Intermediate Steering Shaft Bearing Replacement .
    Fig 1: Installing J-42640 In Steering Column Lower Access Hole
    G01217312Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper intermediate shaft (2) to steering column retaining nut and bolt (1).
  4. Disconnect the upper intermediate shaft from the steering column and remove the upper intermediate shaft.
    Fig 2: Removing Upper Intermediate Shaft To Steering Column Retaining Nut & Bolt
    G01217313Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals