LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Intermediate Steering Shaft Replacement - Lower >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lower intermediate shaft to the vehicle.
  2. Connect the lower intermediate shaft to the intermediate shaft bearing.
    CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the lower intermediate shaft to the intermediate shaft bearing retaining bolt.

    Tighten 

    Tighten the bolt to 30 N.m (22 lb ft).

    Fig 1: Installing Lower Intermediate Shaft To Intermediate Shaft Bearing Retaining Bolt
    G01217319Courtesy of GENERAL MOTORS CORP.
  4. Align the marks made at removal and Install the lower intermediate shaft to the power steering gear.
  5. Install the lower intermediate shaft to the power steering gear retaining bolt.

    Tighten 

    Tighten the bolt to 61 N.m (45 lb ft).

    Fig 2: Installing Lower Intermediate Shaft To Power Steering Gear Retaining Bolt
    G01217320Courtesy of GENERAL MOTORS CORP.
  6. Remove the J-42640 from the steering column lower access hole.
    Fig 3: Removing J-42640 From Steering Column Lower Access Hole
    G01217321Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals