LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 220 (Steering Linkage (Non-Rack & Pinion)) >> Repair Instructions >> Pitman Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitable support the vehicle.
  2. Remove the power steering gear. Refer to POWER STEERING GEAR REPLACEMENT (NON-RACK AND PINION) or POWER STEERING GEAR REPLACEMENT (RACK AND PINION) .
  3. Install the power steering gear into a vise.
  4. Remove the pitman arm nut and washer.
    Fig 1: Removing Pitman Arm Nut & Washer
    G01217286Courtesy of GENERAL MOTORS CORP.
  5. Remove the pitman arm from the pitman shaft using J-6632-01  or J-29107-A  .
    Fig 2: Removing Pitman Arm Using J-6632-01 Or J-29107-A
    G01217287Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals