LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 219 (Power Steering System) >> Repair Instructions >> Power Steering Cooler Pipe/Hose Replacement (GT4) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not start the vehicle with any power steering gear inlet or outlet hoses disconnected. When disconnected, plug or cap all openings of components. Failure to do so could result in contamination or loss of power steering fluid and damage to the system.
  1. Install drain pan under vehicle.
  2. Disconnect the power steering cooler hose from the power steering pump.
    Fig 1: Disconnecting Power Steering Cooler Hose From Power Steering Pump
    G01217133Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the power steering cooler hose from the power steering gear.
  4. Cap the power steering cooler ends in order to prevent the entry of dirt.
    Fig 2: Disconnecting Power Steering Cooler Hose From Power Steering Gear
    G01217134Courtesy of GENERAL MOTORS CORP.
  5. Remove the power steering cooler mounting bolts.
  6. Remove the power steering cooler from the vehicle.
    Fig 3: Removing Power Steering Cooler
    G01217135Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals