LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1902 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Primary and Secondary Latch Replacement

Hood Primary and Secondary Latch Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Hood Latch & Screws
GM1673076Courtesy of GENERAL MOTORS COMPANY
Hood Primary and Secondary Latch Replacement

Callout Component Name

Preliminary Procedure

  1. Remove the headlamps. Refer to Headlamp Replacement (Cadillac Escalade) , Headlamp Replacement (Tahoe, Avalanche) , Headlamp Replacement (Chevrolet Tahoe Two-mode Hybrid) , Headlamp Replacement (Escalade PLATINUM) , Headlamp Replacement (Non HID) , Headlamp Replacement (Yukon) , Headlamp Replacement (GMC Yukon Two-mode Hybrid) .
  2. Remove the grille support. Refer to Radiator Grille Reinforcement Support Replacement .
  3. Disconnect the hood latch cable. Refer to Hood Primary Latch Release Cable Replacement .
1 Hood Latch Screw (Qty: 4)
CAUTION:

Refer to Fastener Caution .


Tighten 
9 N.m (80 lb in)
2 Hood Latch
TIP:  Disconnect the electrical connector.