LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Disc Brakes) >> Removal & Installation >> Rear Disc Brake Backing Plate >> Installation

Rear Disc Brake Backing Plate: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the backing plate to the axle housing flange. Install the backing plate nuts and tighten to specifications. See TORQUE SPECIFICATIONS  .
  2. Install the park brake shoe. See PARK BRAKE SHOE  .
  3. For the 15 and 25 series, perform the following steps:
    1. Install the axle shaft. See appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
    2. Install the rotor. See BRAKE ROTORS  .
  4. For the 35 series with single rear wheels, perform the following steps:
    1. Install the hub assembly. See appropriate WHEEL/HUB REPLACEMENT in REAR SUSPENSION article.
    2. Install the rotor. See BRAKE ROTORS  .
  5. For the 35 series with dual rear wheels, install the hub and rotor assembly. See appropriate WHEEL/HUB REPLACEMENT in REAR SUSPENSION article.
  6. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  in PARK BRAKE SYSTEM under ADJUSTMENTS & INSPECTIONS.
  7. Install the park brake cable to the lever. See Figure . Perform the following procedure to install the cable to the backing plate:
    1. Compress the spring by pushing towards the lever. See Figure .
    2. Route the cable through the slot in the backing plate. See Figure .
    3. Push the cable housing into the backing plate until the locking tabs snap into place.
  8. Install the tire and wheel assembly. Tighten to specifications. See TORQUE SPECIFICATIONS  . Remove the safety stands. Lower vehicle.
  9. Enable the park brake cable automatic adjuster. See PARK BRAKE CABLE AUTOMATIC ADJUSTER  under ADJUSTMENTS & INSPECTIONS.