LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Disc Brakes) >> Removal & Installation >> Park Brake Cable >> Removal (Left Rear)

Removal (Left Rear)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake. Disable the park brake cable automatic adjuster. See PARK BRAKE CABLE AUTOMATIC ADJUSTER  .
  2. Raise and support the vehicle. Disconnect the cable at the equalizer. See Fig 1 .
  3. For cutaway vehicles only, remove the cable from the mounting bracket by depressing the locking tabs.
  4. Pass the cable through the cable guides on the frame. Perform the following procedure to remove the cable (2) from the backing plate:
    1. Compress the spring by pushing towards the lever. See Figure .
    2. Depress the locking tabs.
    3. Pull the cable housing out of the backing plate.
    4. Remove the cable through the slot in the backing plate.
  5. Remove the park brake cable from the lever. Remove the cable from the vehicle.
Fig 1: Identifying Park Brake Cable Equalizer
G00307719Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals