LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Disc Brakes) >> Removal & Installation >> Park Brake Actuator >> Removal

Park Brake Actuator: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake. Disable the Park Brake Automatic Adjuster. See PARK BRAKE CABLE AUTOMATIC ADJUSTER  under ADJUSTMENTS & INSPECTIONS.
  2. Raise the vehicle. Remove the tire and wheel assembly.
  3. Remove the rear park brake cable from the park brake actuator lever. Remove the park brake cable from the mounting bracket by depressing the locking tabs.
  4. Remove the rotor. See BRAKE ROTORS  . Remove the axle shaft. See appropriate AXLE SHAFTS article in DRIVELINE/AXLES.
  5. Remove the park brake shoe. See PARK BRAKE SHOE  .
  6. Remove the backing plate bolts. See Figure . Remove the park brake actuator lever housing from the backing plate.
scientia non olet · About LEMON Manuals