LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Disc Brakes) >> Removal & Installation >> Disc Brake Hardware >> Removal (Rear)

Removal (Rear)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Remove the tire and wheel assembly.
  2. Remove the brake caliper from the brake caliper mounting bracket and support the brake caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the caliper. See BRAKE CALIPERS  .
  3. Remove the disc brake pads from the brake caliper mounting bracket. Remove the disc brake pad retainers from the brake caliper mounting bracket.
  4. Remove the caliper slide pins from the brake caliper mounting bracket. Remove the caliper slide pin boots from the brake caliper mounting bracket. Inspect the disc brake hardware. See REAR DISC BRAKE MOUNTING & HARDWARE INSPECTION  in DISC BRAKE SYSTEM under ADJUSTMENTS & INSPECTIONS.
scientia non olet · About LEMON Manuals