Torque Converter Housing with Fluid Pump Assemble

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Converter Housing With Fluid Pump

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Fluid Pump Slide Fluid Seal Ring
2	Fluid Pump Slide (O-Ring) Seal
3	Fluid Pump Slide Pivot Pin
4	Fluid Pump Slide Seal Support TIP: The seal support is circular. The seal is rectangular.
5	Slide Seal
6	Fluid Pump Slide TIP: If installing a NEW pump slide into the torque converter housing, ensure to properly select the correct rotor and slide before performing this procedure. Refer to Fluid Pump Selective Measurement , and Fluid Pump Selective Specifications .
7	Fluid Pump Slide Outer Spring
8	Fluid Pump Vane Ring
9	Fluid Pump Rotor Guide CAUTION: Align the rotor guide tabs to the notches on the bottom of the rotor. Failure to do so may cause transmission damage.
10	Fluid Pump Rotor TIP: If installing a NEW pump rotor into the torque converter housing, ensure to properly select the correct rotor and slide before performing this procedure. Refer to Fluid Pump Selective Measurement , and Fluid Pump Selective Specifications .
11	Fluid Pump Vanes (Qty: 13)
12	Fluid Pump Vane Ring