Front or Rear Side Door Upper Auxiliary Weatherstrip Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Or Rear Side Door Upper Auxiliary Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Weatherstrip Drip Rail Push Pin Retainers The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Use a J 25070 Heat Gun or equivalent to remove the old weatherstrip. Clean all adhesive residue from the door opening and wipe the surface dry with a clean lint-free towel prior to installing the new weatherstrip. When removing protective liners from the adhesive backed weatherstrip, be careful not to touch the tape with hands. Do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.
2	Weatherstrip Drip Rail Tab Push-In Retainers (Qty: 7)
3	Weatherstrip Drip Rail TIP: Press the weatherstrip firmly to the top side of the door opening to ensure full adhesion is made to the door opening.