LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1739 (Automatic Transmission - ALLISON - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Output Shaft Thrust Bearing Race Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Output Carrier Assembly Bearing Race
    GM1217233Courtesy of GENERAL MOTORS CORP.
  1. Position the output carrier assembly (3) on the press so that the rear of the carrier is facing up.
  2. Install a new bearing race into J 43797:  installer (1).
  3. Using J 43797:  installer (1), press the bearing race (2) onto the output carrier assembly (3) until J 43797:  installer seats.
scientia non olet · About LEMON Manuals