Low and Reverse Clutch Backing Plate Inspection
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Measure the thickness of each low and reverse clutch backing plate (1) at dimension A.
Specification: The low and reverse clutch backing plate minimum thickness is 17.900 mm (0.7047 in).
- Measure the cone of the low and reverse clutch backing plate (1).
- Replace the low and reverse clutch backing plate (1) if any cone is present.
IMPORTANT:
Perform the following measurements at 3 or more locations.