LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1678 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - On Vehicle) >> Valve Rocker Arm Lower Cover Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Valve Rocker Arm Cover (Left)
    GM1335926Courtesy of GENERAL MOTORS CORP.
  1. Install the lower valve rocker arm cover gasket.
  2. Install the lower valve rocker arm cover.
  3. Install the lower valve rocker arm cover bolts.
    4. Fig 2: Lower Valve Rocker Arm Cover Bolts Tightening Sequence
    GM1411029Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  4. Tighten the lower valve rocker arm cover bolts in the sequence shown.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  5. Install the fuel injectors. Refer to Fuel Injector Replacement (Right) or Fuel Injector Replacement (Left) .
  6. Install the upper left valve rocker arm cover. Refer to Valve Rocker Arm Upper Cover Replacement - Left Side .
scientia non olet · About LEMON Manuals