LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1670 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - Off Vehicle (2 Of 3)) >> Valve Lifter Installation (Without Active Fuel Management)

Valve Lifter Installation (Without Active Fuel Management)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Valve Lifter Guides & Bolts
    GM1403319Courtesy of GENERAL MOTORS CORP.
    NOTE:
    • When using the valve lifters again, install the lifters to their original locations.
    • If camshaft replacement is required, the valve lifters must also be replaced.
  1. Lubricate the valve lifters (209) and engine block valve lifter bores with clean engine oil.
  2. Insert the valve lifters into the lifter guides (210).

    Align the flat area on the top of the lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.

    3. Fig 2: Valve Lifter Guides, Cylinder Head & Bolts
    GM1403318Courtesy of GENERAL MOTORS CORP.
  3. Install the valve lifters and guide assembly (210) to the engine block.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the valve lifter guide bolts (211) and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals