Torque Converter Removal and Holding Fixture Installation

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Converter & Holding Fixture

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Torque Converter Assembly
2	Transmission Case Assembly Tip: Rotate the transmission so that the converter housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension. Special Tools DT 47605: Holding Fixture Adapter DT 47605 Holding Fixture. See Special Tools . J 3289-20: Holding Fixture Base Assembly J 8763-B: Holding Fixture For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Torque Converter Assembly

Transmission Case Assembly
Tip:

Rotate the transmission so that the converter housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.

Special Tools

DT 47605: Holding Fixture Adapter
DT 47605 Holding Fixture. See Special Tools .
J 3289-20: Holding Fixture Base Assembly
J 8763-B: Holding Fixture

For equivalent regional tools, refer to Special Tools .