Component Testing
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
You must perform the Circuit/System Testing before proceeding with Component Testing.
- Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle for DTC P254F.
- Inspect the crankshaft position sensor for correct installation. Remove the B26 crankshaft position sensor from the engine and inspect the sensor O-ring for damage.
- If the sensor is loose, incorrectly installed, or damaged, replace the B26 crankshaft position sensor.
- Connect the B26 crankshaft position sensor harness connector to the crankshaft position sensor.
- Ignition ON, engine OFF, observe the Crankshaft Position Active Counter parameter on the scan tool while passing a flat steel object across the tip of the sensor repeatedly. The Crankshaft Position Active Counter parameter should increment with each pass of the steel object.
- If the parameter does not increment, replace the crankshaft position sensor.