Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition ON, engine OFF, command the powertrain relay ON and OFF, with a scan tool, while observing the following powertrain relay coil control circuit status parameters.
- Powertrain relay coil control Ckt. Short Gnd Test Status
- Powertrain relay coil control Ckt. Open Test Status
- Powertrain relay coil control Ckt. Short Volts Test Status
Each parameter should toggle between OK and Not Run or Not Run and OK
- Ignition ON, observe the DTC information with a scan tool. DTC P0685, P0689 or P0690 should not set.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.