LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1645 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0300 To DTC P1175) >> DTC P0641 or P06A6 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect harness connector of the B47 fuel pressure sensor.
  2. Ignition OFF, test for less than 1.0 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K27 fuel pump control module.
  3. Ignition ON, test for 4.8-5.2 V between the 5 V reference circuit terminal 3 and ground.
    • If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K27 fuel pump control module.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K27 fuel pump control module.
  4. If all circuits test normal, replace the B47 fuel pressure sensor.
scientia non olet · About LEMON Manuals