Conditions for Running the DTC
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0068, P0101, P0102, P0103, P0112, P0113, P0116, P0117, P0118, P0120, P0121, P0122, P0123, P0128, P0171, P0172, P0174, P0175, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0221, P0222, P0223, P0300-P0308, P0351-P0358, P0461- P0463, P0496, P0502, P0503, P0606, P0722, P0723, P0806-P0808, P1516, P2066-P2068, P2101, P2135, P2227-P2230 are not set.
- The engine is operating for at least 60 s.
- The engine is idling for greater than 10 s.
- The barometric pressure (BARO) is greater than 70 kPa (11 psi).
- The engine coolant temperature (ECT) is greater than 60°C (140°F).
- The intake air temperature (IAT) is warmer than -20°C (-4°F).
- The vehicle speed is less than 3 km/h (2 mph).
- The commanded engine speed is steady within 25 RPM.
- The transmission is not changing gears.
- The torque converter clutch (TCC) is not changing states.
- The manual transmission clutch pedal position is between 20-88 percent - If equipped.
- The manual transmission clutch is not depressed - If equipped.
- The power take-off (PTO) is not active - If equipped.
- The transfer case is not in 4WD Low - If equipped.
- A scan tool output control is not active.
- The system voltage is between11-18 V.
- DTC P0506 and P0507 run continuously when the above conditions are met for greater than 10 s.