LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1632 (Steering Linkage) >> Repair Instructions >> Steering Linkage Shock Absorber Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Linkage Shock Absorber
    GM1862841Courtesy of GENERAL MOTORS CORP.
    NOTE: Use new steering linkage shock absorber nuts.
  1. Install the steering linkage shock absorber (2) to the vehicle.
  2. Install the steering linkage shock absorber (4) and nuts (1, 3).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the steering linkage shock absorber nuts (1, 3) and tighten to 40 N.m (30 lb ft).
  4. Install the engine shield, if equipped. Refer to Engine Shield Replacement .
scientia non olet · About LEMON Manuals