Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Engine Mount

Courtesy of GENERAL MOTORS CORP.

Position the engine mount to the engine.

Fig 2: View Of Engine Mount To Engine Bolts

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Working through the wheelhouse opening, install the engine mount to engine bolts (1).
Tighten: Tighten the bolts to 50 N.m (37 lb ft).
Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
Remove the adjustable jack from the engine block.

Fig 3: View Of Engine Mount To Frame Bolts

Courtesy of GENERAL MOTORS CORP.

Install the engine mount to frame bolts (1).
Tighten: Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
Install the A/C compressor bracket. Refer to Air Conditioning Compressor Bracket Replacement (Non-HP2) or Air Conditioning Compressor Bracket Replacement (HP2) .
If the vehicle is equipped with 4WD, Install the front drive axle bracket and bolts.
Tighten: Tighten the bolts to 90 N.m (67 lb ft).
If the vehicle is equipped with 4WD, Install the front drive axle. Refer to Differential Carrier Assembly Replacement (1500 FWD) or Differential Carrier Assembly Replacement (2500 4WD) .
Install the exhaust manifold. Refer to Exhaust Manifold Replacement - Right Side (V8) or Exhaust Manifold Replacement - Right Side (6.6L) or Exhaust Manifold Replacement - Right Side (V6) .